Plumbing Service In Colton CA

JIG Plumbing will install (2) client supplied 4 inch spread faucets. Technician will install (2) pop up assemblies and will provide and install a total of (4) emergency 1/4 turn shut off valves with steel braided supply lines. Once completed technician will pressurize the home to insure there are no leaks and that the faucets are secured. WARRANTY: 1 year on leaks, labor and material DISCLAIMER: client supplied items are not under warranty

I handled a gas line repair today in Colton. The homeowner smelled gas near their stove. Using a gas leak detector, I located a small leak in the copper gas line. After shutting off the gas supply, I replaced the damaged section of the line and retested for leaks, ensuring safety.

In Colton, I repaired a toilet with a faulty Fluidmaster fill valve. The toilet was constantly running and wasting water. I replaced the old fill valve with a new Fluidmaster 400A and adjusted the water level for proper function. The repair saved water and resolved the customer’s issue immediately.

Upon arrival technician was able to determine source of damage caused by a sudden leak on copper piping within the wall. Technician was able to eliminate leak and proceed with repair.

Earlier today I finished the installation of a new natural gas line in Colton, CA. The project involved laying 30 feet of Type L copper piping, which is ideal for indoor gas distribution. I connected the line to the main supply with an approved gas shutoff valve and tested for leaks using a manometer to ensure the system’s integrity and safety. The installation meets all local building codes for residential properties.

Repaired a leaking kitchen sink faucet in Colton, CA. Turned off supply lines and removed faucet fixture. Inspected ceramic cartridges and noticed scoring on stems. Replaced with new Danco cartridges and reinstalled faucet using plumbers putty. Turned water back on slowly to check for drips. Used a basin wrench to tighten down faucet nuts and secure mounting. Tested hot/cold operation - leak resolved.

Replaced customer supplied pre and post filers on Aquasauna filtration. Removed 2 kitchen dispensers and installed covers in place. Checked customer supplied tub spout and found that attaching stub out to be wrong. Customer changed her mind.

Supply and install Navien NPE 180 unit with necessary installation materials and equipment. This is for existing location.

Due to burst water piping in wall of home at PEX manifold block, we will be supplying and installing new PEX manifold block and reconnecting to existing piping. This may require some removal of walls and or stud but does not include any repairs beyond the Manifold block and the pipe connections directly to it.

The client heard strange noises in the pipes. Conducted a thorough inspection, identifying air pockets. Purged the air from the pipes, eliminating the noise and improving plumbing system performance.

Technician will install garbage disposal due to existing one leaking. Once finished technician will then remove existing wide spread faucet and install client supplied faucet. Once scope of work is complete technician will run water to insure their are no leaks and optimal flow is occurring. WARRANTY: 1 year on leaks labor and garbage disposal itself. 90 day warranty on leaks and labor for client supplied faucet.

Upon arrival technician diagnosed a garbage disposal leak and wide spread faucet drip. Technician recommended to replace faucet and garbs disposal due to manufacturer defects.