Plumbing Service In Glendora CA

.

Existing heater has an unknown service record, and is giving the homeowner issues with hot water delivery. There is currently not any filtration to the heater. JIG Plumbing will remove the existing water heater and install a new Navien tankless water heater S unit that includes scale inhibitor, which will reduce the amount of scale going in to the unit. The piping round the unit will be reworked to accommodate the Navien, and new gas supply line will also be installed. Labor warranty for a period of 2 years starting on the day of installation.

JIG Plumbing will re-pipe the drainage of underneath the home, up to where the drains meet the subfloor. The existing cast iron will be removed, and any subterranean areas will be dug out in order to access the piping. New pipes will be installed, using ABS pipe and fittings. Once complete, the system will be thoroughly tested to ensure proper flow. Parts and labor warranty for up to two years from date of service. 10 yr workmanship warranty parts and labor.

JIG will break the concrete to perform a spot repair. The technician broke a rectangle of concrete by the old drinking fountains by the parking lot. The technician dug out the dirt and old asphalt and located the burst 3/4” galvanized pipe. The technician cut the pipe, cleaned the pipe, and capped it with a compression x MPT adapter. The technician pressurized the system and waited 10 minutes after the system was fully pressurized. The cap was not leaking. The technician braced the pipe with a block of wood and backfilled the area with the existing dirt. The technician put a rough patch of concrete in order to finish the work. There is no warranty on repairing an existing buried galvanized line because the moisture in the soil compromises the integrity of the pipes. It is recommended to replace all galvanized pipes with polypropylene, PEX, or copper piping.

Customer stated he fixed the issue himself using a plunger and would no longer need our service.

JIG Plumbing will perform a camera inspection to determine the quality of the drain piping under the home. Once inspected, if any issues are found, a plan of correction will be formulated, in order to proved the homeowner with the best possible solution.

JIG will carefully use a toilet auger to attempt to clear the stoppage. If the auger is unsuccessful, we will escape to clearing the line through the cleanout or by removing the toilet There is no warranty The back restroom toilet keeps running. JIG will rebuild the toilet tank with a new fill valve and new flapper to tune it up. Should the toilet keep running after the tune up, we will recommend a full tank rebuild, including the Douglas valve and tank to bowl connection, or a new toilet. 30 day warranty Inspected the rest of the bathrooms and trap of the three faucets are leaving when run. One of them is dripping from the spout. It is recommended to rebuild the faucets or to replace them. See estimates

Jig Plumbing will camera inspect via access clean out. Technician will locate and gather exact footage of the sewer line. JIG Plumbing will hydro jet via access sewer clean-out. Technician will utilize approximately 3500 psi in order to remove root intrusion currently existing. Technicians will camera inspect sewer line before and after the work is completed. DISCLAIMER: Warranty will be granted upon completion of the work in order to determine the condition of the sewer line. JIG Plumbing will crawl underneath home in order to make a sectional repair on a 1/2 inch copper line. Technician will have to modify copper in order to due so. Once scope of work is completed technician will then pressurize system to insure there are no more leaks occurring. WARRANTY: 1 year on leaks, labor and material. On copper repair.

Upon arrival customer had stated the toilet was backing up and happens very often . The tenant will be paying for the invoice for today. A recommend estimate to pull toilet will be applied to camera the line. No warranty will be applied due to the continuous issues in the home.

Replace existing 100 Gallon Heater with new Commercial 75 gallon water heater to code. We will repair leak at existing water line in closet, replace upstairs expansion tank and t&p at leaking water heater. Replaced 2 gallon expansion tank with a 4 gallon expansion tank. Checked for water and gas leaks. 3 yr commercial manufacturer warranty 1 yr labor.

Upon arrival, manager showed me middle restroom toilet, which had and was continuing to overflow. There are three restrooms on the property, the front restroom is flushing fine, but the back restroom was reported to need two flushes and many people were still using it. Removed the cleanout behind the middle toilet to clear the blockage, however, did not hear any water in the line. Escalated the project from $457 to $642. Attempted to auger the toilet, but the auger became stuck in the trap. Removed the toilet and inspected the flange, which is in working condition. Removed paper towels from the base of the toilet, but could not see anything or remove the auger from the toilet. Removed paper towels that were flushed and creating the blockage, but was not the issue that was trapping the auger. Escalated the project to a toilet replacement for $1,100. Broke the p trap and found a defect in the toilet. At the top of the trap, there was a defect hole in the porcelain, which trapped my spri

JIG Plumbing will supply and install a tank-type water heater, as the existing is leaking and no longer functioning. Technician will drain and remove the existing heater, and install the new heater, using a new shut off and supply lines. Once installed, the unit will be filled, tested for leaks, and turned on to begin heating. The old heater will be hauled away at no additional charge. Parts and labor warranty for up to one year from date purchase.

This work includes new hot and cold Uponor water pipe, new emergency shut off valves and supplies, new main water PRV and ball valve, up to 2 hose bibs, up to 2 tub/shower valves (chrome) patch of walls to paint ready conditions, 25 yr manufacturer warranty, 1 yr labor warranty, 1 yr warranty on stops, supplies, and valves.

JIGPlumbing will remove and replace a 75 gallon water heater, and haul away the old one. The recirculating pump was disconnected upon arrival, so it was left the same way and the ball valve also in the off position. Included with the heater are new water supply lines, gas flex hose, sediment trap,and expansion tank. 2 year warranty on parts and labor

Reroute hot and cold water lines from the old water heater closet into the wall. To do so the technician demoed plaster wall and cut out old galvanized water lines from the wall down to the crawlspace. The technician then drilled holes and ran two 3/4” PEX water lines from the crawlspace, through the wall, and up into the attic. The technician connected to copper hot and cold water lines in the crawlspace and attic. The technician also plugged a galvanized water line in the wall. Once complete, the technician turned on the water and inspected for leaks and found a leak on one of the fittings so the technician cut out section and rebuilt. The technician turned on the water and tested again. No other leaks were found. Warranty: 1 year parts and labor on rerouted water lines JIGPlumbing will snake the branch line from the 3” clean out at crawl space. Wipes and accumulation out. No warranty due to the wipes.

JIGPlumbing attempted to snake the kitchen sink drain line from an exterior clean out on 2/4/25 an was unable to clear the stoppage. On 2/5/25 the technician came out again to snake the drain line using the Rigid flex shaft, and the 1/4 gorlitz machine. While snaking the drain line the water was running the entire time and it didn’t back up. The drain line appears to be clear, however JIGPLUMBING is recommending to have this drain line Hydrojetted to clean the drain pipe from any sludge or debri buildup. 30 day warranty.

Arrived to inspect a bathtub drain leak. Anthony ran water and found that the waste and overflow connection to the drain is compromised. Took photos and Jason discussed solutions with Anthony. Also found the water pressure to be at 115psi. We will also replace the PRV tomorrow along with the drain and tub. Noah and Jerry scheduled for tomorrow. While I was on site, Anthony was notified that they did not have hot water so I took 30 seconds to relight the Bradford White WH for the building. Came back 1/30 and removed existing bathtub, shower valve, and pressure regulator. Installed new 3/4” Pressure regulator on the riser. Checked pressure and it’s within a normal range. Removed existing cast iron p trap and installed new 1-1/2” absp trap. Installed new Americast white bathtub and adjusted 2x4 horizontal level to support the tub. Installed new waste and overflow for the tub. Also installed new Moen posi-temp shower valve and new 1/2” copper for the tub spout. Left shower riser as is per

Drain cleaning through accessible clean out access. With 30 day stoppage warranty except in cases of damage, roots, and or abuse.

Customer requested to shut down, close the water to the R.O system. The technician noticed water leaking from the filter housing and shut it down. The hot and cold water is still being able to use for the faucet.

Hallway restroom lav. Upon arrival customer said he only issue was low pressure on lav. Water pressure everywhere else is good. Removed the existing aerator and put a new one. Water pressure working properly, customer satisfied. This was done as a courtesy for a return customer.

Upon arrival, both toilets in classroom A are backed up and water backed up in floor drain. There is a restroom on the back side of the toilets (office restroom) with a clean out on the same wall as the toilets. Attempted to remove the abs clean out cap but it wouldn’t unthread, only started to bend the plastic square. Used a multi tool to cut out the cap. Ran a camera down the drain but no water was holding. JIG Plumbing will remove the left side toilet in room A and snake through the pulled toilet. We will run lots of water to check the drain flow. We will reset the toilet with new bolts and a new wax ring. Pulled out wipes from the drain. See photos. Ran the camera as far as it would go down the toilet flange-50 feet. Did not see any obstruction except for one wipe 50 feet out. Pipe looks to be in good shape at this time. When reconnecting the Sloan valve to the toilet bowl, tailpiece would not stop leaking at connection to the valve body. Also, when attempting to remove tailpie

Upon arrival the customer took me to the first issue, at the last building rear kitchen. The floor sink drain under an ice machine stoppage. The technician was able to get underneath and snake at trap and line to clear the stoppage, accumulation out. Second was a commercial double sink at the second building kitchen next to the library’s media center. The drain on the right side has a stoppage. The technician was able to drop the trap and snake the drain , successfully clearing the stopppage, accumulation out.

Replace existing disposal with new standard grade disposal.

JIG Plumbing will Jack hammer and remove section of concrete in order to gain access to ground soil. Technicians will then excavate soil in order to expose existing main water line. Once pipe is exposed technician will then repair section of pipe in order to eliminate existing leak. Once completed technician will then pressurize line to insure there are no more leaks occurring. Technicians will then backfill and compact existing soil, and will then provide a rough patch of concrete. WARRANTY: 6 months on leaks, Labor and material.

JIG will dig up new 1” copper main and tee off to reconnect sprinkler valves by garage. We will run 3/4” pipe as deep as 12” across the grassy area, stubbing up shallow and cutting through the foliage to reconnect to existing 1” pvc with a new brass ball valve. Checked for leaks before backfilling, shadowed the pipe with dirt to set it in place. Made sure the sprinklers received water from the feed before backfilling. Cleaned up excess dirt and put rocks back in their place, watering the lawn to promote St. Augustine growth. Removed large chunks of dirt clods by the garden hose and put down bags of rocks to fill in empty spots.