Plumbing Service In Riverside CA

Technician will re-route all existing hot water lines due to existing conditions. Technician will install PEX piping within the walls and will reconnect onto hot water heater. Technician will utilize copper stub outs for emergency shut off valves for the kitchen and vanity sink. Technician will then reconnect onto existing shower valve. Once complete technician will pressurize unit to insure there are no leaks. WARRANTY: 2 years on leaks labor and material DISCLAIMER: Any galvanized connection point will not be under warranty. Technician will attempt to limit any reconnection onto to galvanized piping.

Direct access repair for leaks in slab/sub surface inside of home. $2200 for access To perform direct access repair of burst water line in slab of home which will include removal and replacement of concrete. No drywall, tile, flooring repair or removal of vanity, cabinetry, etc. $484.18 for pipe repair. Discount applied to account for work not performed to completion as owner has requested work placed on hold. JIG has informed customer that our initial recommendation of either re-routing or re-piping is necessary due to age and conditions of galvanized pipe in slab being in state where repairs are not sufficient. DISCLAIMER: Technicians utilized isolation valve for hot water heater in order to shut off water. Due to the concrete being exposed and slight water still leaking on the pipe, technicians are not responsible for any possible puddling within the home due to current work being paused.

JIG Plumbing will supply and install a new 10-inch rough toilet, chrome tub/shower valve, and chrome tub waste and overflow in Riverside, CA. To provide proper access to the bathtub plumbing, we will open the wall inside the closet. Please note, drywall repairs are not included in this scope of work but can be added upon request. Our professional team ensures precise installation for long-lasting performance. Contact JIG Plumbing for expert toilet installation and bathroom plumbing services in Riverside, CA.

After 3/4 copper water line was exposed we discovered that There was a significant pinhole leak that was causing water to seep out from concrete We cut and modified sectional copper. We also applied 10 mil tape in order to protect newly repair that was completed. After repair was completed we then pressurize, hot and cold water system, and verified client had hot water throughout home and proper pressure. We did apply rough patch of concrete over repair that was made. We are not responsible for drywall.

Upon arrival, the technician was informed that maintenance tried to snake the urinal but was unsuccessful. The technician then attempted to auger the urinal but was also unsuccessful. The technician then, upon approval, disassembled and remove the urinal from the wall and used the descale machine to break up and clear debris from the line. After this was completed the technician the. Reinstalled the urinal with a new gasket. Upon reassembly, the technician found the Sloan valve was leaking. The technician then rebuilt the Sloan valve and replaced the urinal spud. After work was complete, the technician thoroughly tested the urinal for leaks and functionality. Warranty: 14 day warranty on commercial stoppage at urinal due to pull and reset requirements. 30 day commercial warranty on urinal flushometer rebuild

Upon arrival, the technician was shown a toilet that was leaking from the spud. The technician then turned off the shut off valve and disassembled the valve to remove the spud. After the spud was removed, the technician then installed a new toilet spud with a new spud coupling and a new vacuum breaker and then proceeded to reassemble the valve. Once the valve was back together, the technician then tested the valve thoroughly for leaks and functionality. Warranty: 30 day commercial warranty unless abuse.

Upon arrival technician recommended to replace shower valve due to age and constant leak occurring.

Install a standard 50 gallon natural gas water heater Bradford and White with new water and gas supplies, new water and gas shut offs, new sediment trap, new expansion tank, haul away old. Warranty: 2 yr labor 6 yr manufacturer warranty.

Technician will repair small section of leaking irrigation utilizing barbed fittings.

Technician will utilize electronic leak detection equipment in order to determine cause of leak. In conclusion to leak detection, technician was able to determine that Unit C is experiencing a hot water slab leak. Technician was also able to determine a general vicinity of where the leak is. Technician believes leak is originating from the main Hot water feed and or could possibly be feeding the lavratory sink in hallway restroom.

Upon arrival, the technician determined that a specific fitting was required to properly connect the refrigerator to the ice maker valve. After assessing the setup, the technician identified the correct adapter fitting to ensure a secure connection. The fitting was installed between the refrigerator’s water line and the valve, ensuring no leaks and proper water flow. After completing the installation, the technician tested the ice maker, confirming it was receiving water and functioning properly.

Upon arrival after technician was able to determine problem technician proposed multiple options in order to eliminate ongoing issue.

JIG arrived to further expose section of failed sewer line (Orangeburg) at tank inlet at septic. After exposing the tank inlet we then chipped away at concrete to allow for connection to line into tank. Once exposed at connection the repair was made with two no-hub style connectors and new ABS pipe and fittings. Due to nature of repair and existing conditions of Orangeburg pipe it is highly recommended to replace sewer line and warranty will be limited to 1 yr on repair only.

Upon arrival, repaired a small section of the irrigation system where a leak was identified. Applied a warranty for the repair, considering the leak’s location. However, due to the need to modify the irrigation piping, this section falls outside the original warranty scope. As a result, the modified piping will not be covered under the existing warranty. The repair was completed, and the irrigation system is now functioning properly, but with the noted warranty exception for the modified area.

Upon arrival, the technician performed the main gas meter installation. This involved carefully positioning the meter, securing all connections, and ensuring compliance with safety regulations and local codes. The technician meticulously checked for any potential gas leaks and verified the accuracy of the meter readings to ensure proper functioning. After completing the installation, the technician conducted a final inspection to confirm that the meter was securely installed and operating efficiently, providing the homeowner with a reliable and safe gas supply.

Upon arrival technician replaced shower cartridge in hallway restroom under warranty.

Upon arrival due to the continuous growth of bacteria within the cracks of the grout inside the master bath shower. Technician believes shower pan can possibly be cracked and or a waste and overflow from either tub, would most likely be the source of issue. Technician was able to also determine that the home is not experiencing a pressurized leak. RECOMMENDATION: Technician highly advises to remove drywall in between restrooms and master room in order to see where water is traveling.

We went out to Riverside this evening, the homeowner reported a shower stoppage likely caused by debris. Our technician used a RIDGID K-45 drain cleaner to carefully snake the shower drain, breaking up and removing the blockage. After clearing the debris, we flushed the drain with hot water to ensure proper flow and checked the P-trap for any remaining obstructions. The shower drain was tested and confirmed to be functioning correctly. Regular maintenance can prevent such issues and ensure smooth drainage. Trust our team for reliable plumbing solutions.

Technician will utilize electronic leak detection. In conclusion to leak detection technician was able to confirm that the home is not experiencing any slab leaks. Technician believes damage that had occurred was on going possibly due to the flooring.

Upon arrival technician was unable to determine if a slab leak is occurring. Technician did not see any movement on the main water meter but suggests to utilize electronic leak detection equipment in order to conclude no slab leak is occurring. NOTE: Current psi incoming to the home is over 80 psi which is deemed harmful to the home by the state of California, technician highly recommends replacement of the PRV.

Upon arrival, I confirmed the homeowner was experiencing a partial main line stoppage. Using a sewer camera inspection, I identified a blockage restricting flow. This was caused by debris buildup and root intrusion. Recommended hydro jetting to thoroughly clean the line and prevent further issues. Regular inspections and maintenance can help avoid costly repairs in the future.

Upon arrival technician utilized electronic leak detection equipment to determine source of leak. In conclusion to diagnosis technician was able to conclude that the home experience cold water slab leak. Water from the slab leak would saturate the soil and concrete slab and would eventually be on surface flooring.

Upon arrival, installed oil-rubbed bronze trim in the master shower. Removed existing trim and cleaned the installation area. Carefully fitted and secured the new oil-rubbed bronze trim, ensuring a precise and secure attachment. Aligned the trim with the shower fixtures for a seamless look. Tested the fixtures to ensure proper operation and no leaks. The new trim enhances the shower's appearance with a stylish, modern finish. Cleaned the work area and reviewed the installation with the homeowner.

JIG plumbing will begin repipe process by setting up containment zones and walkways throughout the home. Technicians will have to make multiple drywall incisions and or stucco incisions in order to begin repiping home utilizing uponore PEX. Technicians will then begin to install new ice maker box, laundry valves, emergency shut-off valves underneath all fixtures, supply lines, exterior hose bibs, water service riser and new shower valves and trim all up to California code standard. Once complete technicians will then pressurize home to insure there are no leaks. Drywall patch and texture is included on the scope of work. WARRANTY: 25 year manufacturing on pex 10 year warranty on leaks, labor and materials DISCLAIMER: Drywall will be patched and textured to be paint ready. (PAINTING WILL NOT BE INCLUDED).

During a recent service call, I determined that the shower valve needed replacement. The existing valve was corroded and causing inconsistent water flow. I shut off the water supply, removed the faulty valve, and installed a new, high-quality valve. After installation, I tested for proper water pressure and temperature regulation, ensuring optimal performance.